Hey JB question on the motor you sent

Got the motor and it looks great.

It should fit but, the carb I have is to big for the ports. Do you have the original for it so I know what to get?

Also do they make throttle shaft rebushing kits for these carbs?

I have one that might fit if I can get the elbow for the intake, but the throttle shaft is egged out pretty bad.

I have a bucket full of those carbs, not sure which one was on that engine but it was funky, wouldn't rev up.
I don't know of a rebush kit, there might be one. I usually just find one off another donor so I've never looked. But I did buy a new carb for a 14 horse Kohler in a 145 Ford garden tractor. My machinist could have saved it if it was just the bushings but it also wollered out the throat from the butterfly moving around.

What would it take to at least get the intake elbow for it?

I can fool around with a carb here if that one is toast.

I guess the engine I have uses bigger ports soo.....

Uhmm... I didn't catalog the parts, the carb is in a box with a dozen other ones.

Ahh I see, JB

If I give u the measurements of the port could u match one up?????

Should be able to. Do you need the intake part or just the carb?

Intake part for sure, carb would be a bonus.

Finally got the measurements on that carb for ya JB.

Intake hole is 7/8 inches, Bolt to bolt measurement is 1 13/32 inches.

just about pecker size